Kemppi SF 51 Manual do Utilizador

FastMigSF 51, SF 54Operating manualBruksanvisningGebrauchsanweisungManual de instruccionesKäyttöohjeManuel d’utilisationManuale d’usoGebruiksaanwijzin

ENRemote Selection Button (13)Remote control unit is connected to the device by pressing button 13. The wire feed speed and welding voltage setting op

ENAuto Wire InchAIn OFF, on on SuperSnake Automatic Wire Inch function. Wire Inch button runs the ller wire from the wire feeder up to the SuperSnake

EN3. FASTMIG ERROR CODESThe existence of possible faults in the equipment is investigated in connection with each wire feed unit start-up. If a fault

ENErr 171: Conguration not found for the deviceThe equipment’s internal data transmission has been cut o. The optional features cannot be used. Turn

www.kemppi.com19234401515KEMPPI OYKempinkatu 1PL 13FIN-15801 LAHTIFINLANDTel +358 3 899 11Telefax +358 3 899 [email protected]

OPERATING MANUALEnglish

ENCONTENTS1. Preface ... 31.1 General ...

EN1. PREFACE1.1 GeneralCongratulations on choosing the SF panel. Used correctly, Kemppi products can signicantly increase the productivity of your

EN2. USEFastMig SF 51 and SF 54 panels are supposed to be used only with synergic powers sources FastMig KMS 300, 400 or 500. SF 51 panel can be moun

EN2.2 Functions of SF 51 and SF 54 function panelDYNAMICSWIRE INCHGAS TESTwelddataARC FORCEVAm/min4TSETUP2TUMMAMIGMMAPANELSF 51W0013181. 2. 3. 4. 5.

EN2.3 SF 51 and SF 54 operationsON/OFF (1)The wire feed unit remains in the OFF position when the power source is switched on, thus preventing start-

ENGas test (5)The gas test button opens the gas valve without activating the wire feed or power source. Gas ows for 20 seconds by default. The displa