Kemppi Evo 300 Manual do Utilizador

FitWeldEvo 300Operating manualBruksanvisningGebrauchsanweisungManual de instruccionesKäyttöohjeManuel d’utilisationManuale d’usoGebruiksaanwijzingBrug

FitWeld Evo 3008EN2.5.3 Setting the pressure of the feed rollsTo make ller wire run smoothly into the wire liner and to the welding gun you can adju

9© Kemppi Oy / 1515 EN2.5.5 Wire guide tubes and wire feed rollsMake sure that you select appropriate wire feed rolls/groove type, welding gun cont

FitWeld Evo 30010EN2.5.6 Changing the feed rollsTo change the feed rolls: 1. Pull and release the pressure tension arm via the aluminium head above

11© Kemppi Oy / 1515 EN2.6 Controlling welding functionsWith FitWeld Evo 300 you can easily control welding parameters, change the welding polarity

FitWeld Evo 30012EN2.6.2 Controls inside the machine3.1. 2.1. Welding gun operation mode switch.2. Shielding gas adjustment screw.3. Cable connect

13© Kemppi Oy / 1515 EN2.6.4 Adjusting the shielding gas owUsing a rotameter as shown in the picture, you can adjust the gas ow rate to the gun b

FitWeld Evo 30014EN2.7 TroubleshootingProblem CauseThe machine stops working and the shielding gas indicator is lit.The maximum ow rate at the gas c

15© Kemppi Oy / 1515 EN3. MAINTENANCEWhen considering and planning routine maintenance, please consider the frequency of machine use and the workin

FitWeld Evo 30016EN4. ORDERING CODESFitWeld Evo 300FitWeld Evo 300 + FE32 3,5M P2103FitWeld Evo 300 + FE32 5M P2104FE32 3,5M 6603203FE32 5M 6603204FE

17© Kemppi Oy / 1515 EN5. TECHNICAL DATAConnection voltage3 ~, 50/60 Hz 220 V -10% ... 440 V +10 %Rated power at max. current10.8 kVASupply current

www.kemppi.com1903530 1515KEMPPI OYKempinkatu 1PL 13FIN-15801 LAHTIFINLANDTel +358 3 899 11Telefax +358 3 899 [email protected]

OPERATING MANUALEnglish

FitWeld Evo 3002ENCONTENTS1. Introduction ... 31.1 General ...

3© Kemppi Oy / 1515 EN1. INTRODUCTION1.1 GeneralCongratulations on choosing the FitWeld welding machine. Used correctly Kemppi welding machines ca

FitWeld Evo 3004EN2. USING THE MACHINE2.1 Before useThe product is packed in cartons designed specically for them. However, always make sure before

5© Kemppi Oy / 1515 ENFor quick help about starting with FitWeld, please refer to the Quick Guide delivered with the product information package. 2.

FitWeld Evo 3006EN2.4.4 Welding gunConnect the welding gun cable to the Euro adapter socket located on the front panel and hand tighten only. Do not

7© Kemppi Oy / 1515 EN2.5.2 Feeding in the welding wireNOTE! Remember to remove the sharp cut tip of the ller wire before loading the wire to the